NDS® 2018 Standards Tutorial 1: Combined Bending and Axial Compression Example (ASD)
The example is taken from the 2015 NDS Examples – Beams, Säulen, and Beam-Columns (DES220). Seite 53.

A No. 2 Southern Pine 2×4 oriented flatwise is being considered for use as a member within the top chord of a parallel chord gable end truss. The member is 3 ft long (between panel points) and will be subjected to axial compression forces of 300 Pfund (DL) und 600 Pfund (SL), concentrated loads of 50 Pfund (DL) und 100 Pfund (SL) at the midpoint of the member on its wide face and 120 Pfund (WL) of the midpoint of the member on its narrow face. Lateral support is provided only at the ends of the member and the ends are considered pinned.
Check the adequacy of the beam-column for bending and compression for the appropriate load cases.
Schritt 1 die Einstellungen

Schritt 2 Add Nodes

Schritt 3 Auf der Registerkarte können Sie alle Mitglieder definieren, mit denen Sie arbeiten, indem Sie auf klicken

Schritt 4 Unterstützung hinzufügen

Schritt 5 Auf der Registerkarte können Sie alle Mitglieder definieren, mit denen Sie arbeiten, indem Sie auf klicken

Schritt 6 Add Section

Schritt 7 Add Load

Schritt 8 Lastkombinationen hinzufügen

Schritt 9 Perform Analysis

Schritt 10 Perform Design

Schritt 11 Vonsign parameters

Schritt 12 Design parameters. Run design

Schritt 13 Design Result

Eine detaillierte Beschreibung dieses Formats und die Regeln für seine Vorbereitung finden Sie hier




