SkyCiv文档

您的SkyCiv软件指南 - 教程, 使用指南和技术文章

SkyCiv会员设计

  1. SkyCiv会员设计
  2. 代码验证
  3. 如 1720 代码验证

如 1720 代码验证

如 1720 – 2010 Code Verification using The Timber Design Handbook HB-108 – 2013 by Standards Australia

 

HB 108-2013 coverpage

Information presented on this page is intended to demonstrate the agreement in results between a trusted source and those which have been calculated in the member design module. All examples are taken from The Timber Design Handbook HB-108-2013 published by Standards Australia.

注意: Calculations in the Timber Design Handbook HB-108 – 2013 round values to 3 significant figures however, SkyCiv does use this approach. Values in SkyCiv are calculated with maximum accuracy and reported to 3 decimal places which may cause some minor disagreement between values in the following comparisons.

Design of Tension Members

例 3.3 – Tension capacity of a bottom chord in a roof truss

Variable HB-108 SkyCiv 区别 (%)
一个Ť 5.11 X 103毫米2 5.11 X 103毫米2 0
ñdtķ1 25.4千牛 25.397千牛 -0.0118

Design of Compression Members

例 4.1 – Compression capacity of a bottom chord in a roof truss subject to wind uplift

Variable HB-108 SkyCiv 区别 (%)
[R
1 1 0
ρC 0.86 0.864 0.465
小号3 14.7 14.74 0.272
小号4 80 80 0
ķ12 0.042 0.042 0
ñdc 3.54千牛 3.505千牛 -0.989

评论: 在这个例子中, r has been set to 1 for the purpose of checking the accuracy of the calculated results however, normally SkyCiv assumes a value of 0.25 which is conservative an may reduce the capacity of the member by approximately 15-20% if there is a stress reversal in the member for the governing load combination or if the member is designed to carry mostly temporary loads. Future versions of the software may include the calculation of r.

例 4.3 – Compression capacity of stud in frame

Variable HB-108 SkyCiv 区别 (%)
[R
0.25 0.25 0
ρb 1.08 1.082 0.185
小号3 20.1 20.20 0.496
小号4 35.1 35.11 0.0285
ķ1 0.57 0.57 0
ķ4 1.1 1.11 0
ķ12 0.139 0.139 0
ñdc 7.05千牛 7.023千牛 -0.383

 

Design of Bending Members

例 5.6 – Design of a floor beam for strength

Variable HB-108 SkyCiv 区别 (%)
[R
0.25 0.25 0
ρb 0.84 0.844 0.476
小号3 20.1 20.20 0.496
小号4 35.1 35.11 0.0285
ķ12 1.0 1.0 0
中号dzķ1 44.4千牛·米 44.627千牛·米 0.0511
本文对您有帮助吗??
是的 没有

我们能帮你什么吗?

回到顶部