Type d'analyse
Linear Static – static analysis, takes into account elastic material properties
Flambement linéaire - analyse de stabilité linéaire pour un nombre sélectionné de modes propres.
Geometry Nonlinear Static – iterative analysis, takes into account elastic material properties and geometry nonlinearity (grandes cylindrées)
Géométrie + Matériau statique non linéaire - l'analyse statique itérative prend en compte la non-linéarité du matériau et de la géométrie (grandes cylindrées)
Géométrie + Material Nonlinear Dynamic - l'analyse dynamique itérative prend en compte la non-linéarité des matériaux et de la géométrie (grandes cylindrées)
Paramètres statiques
Facteur de charge global - le facteur sera multiplié par toutes les valeurs de charge dans le modèle pour l'analyse
Période de temps et incrément de temps - paramètres d'analyse d'itération. Ces paramètres pour la plupart des cas d'analyse sont configurés correctement et peuvent être utilisés par défaut.
Paramètres dynamiques
Période de temps et incrément de temps - paramètres d'analyse d'itération.
Étapes de sortie des résultats – pour l'enregistrement des résultats pendant l'analyse
Damping – Rayleigh damping, alternatively termed proportional damping, represents a variant of viscous damping allocated throughout the elements. This approach constructs a damping matrix, noté comme , through a linear amalgamation of the mass matrix and the stiffness matrix
Load Amplitude
In nonlinear finite element analysis, the load-time function is a critical feature that defines how loads are applied over time. The software provides the capability to assign varying load intensities at different instances, which is especially useful in simulating real-world conditions where loads are not constant.
To enhance this functionality, the software allows the definition of two amplitude options for the loads. These amplitude options enable users to specify a pattern or a sequence of load values that change over the course of the analysis.
The first amplitude option can define the initial ramp-up of the load, allowing for a gradual increase from zero to the maximum load value, reflecting a more realistic application of force or pressure on the structure. The second amplitude option can describe a subsequent phase, such as a holding pattern, cyclic loading, or a decrease to simulate the removal of the load.
If you only need to deal with a single load amplitude, where all applied loads follow the same function, use ‘Amplitude 1’ as an example. The program will ignore the second amplitude if it is not used.