SkyCiv-documentatie

Uw gids voor SkyCiv-software - tutorials, handleidingen en technische artikelen

SkyCiv-lidontwerp

  1. Huis
  2. SkyCiv-lidontwerp
  3. Code verificatie
  4. NDS® 2018 Code verificatie

NDS® 2018 Code verificatie

NDS® 2018 Standards Tutorial 1: Combined Bending and Axial Compression Example (ASD)

The example is taken from the 2015 NDS Examples – Beams, Kolommen, and Beam-Columns (DES220). Bladzijde 53.

AWS_Exam

A No. 2 Southern Pine 2×4 oriented flatwise is being considered for use as a member within the top chord of a parallel chord gable end truss. The member is 3 ft long (between panel points) and will be subjected to axial compression forces of 300 lbs worden toegevoegd om gelijk te zijn aan a (DL) en 600 lbs worden toegevoegd om gelijk te zijn aan a (SL), concentrated loads of 50 lbs worden toegevoegd om gelijk te zijn aan a (DL) en 100 lbs worden toegevoegd om gelijk te zijn aan a (SL) at the midpoint of the member on its wide face and 120 lbs worden toegevoegd om gelijk te zijn aan a (WL) of the midpoint of the member on its narrow face. Lateral support is provided only at the ends of the member and the ends are considered pinned.

Check the adequacy of the beam-column for bending and compression for the appropriate load cases.

Stap 1 Instellingen

Step1

Stap 2 Add Nodes

Step2

Stap 3 tabblad is waar u leden kunt definiëren waarmee u werkt door op de

Step3

Stap 4 Ondersteuning toevoegen

Step4

Stap 5 tabblad is waar u leden kunt definiëren waarmee u werkt door op de

Step5

Stap 6 Add Section

Step6

Stap 7 Add Load

Step7

Stap 8 Voeg lastcombinaties toe

Step8

Stap 9 Perform Analysis

Step9

Stap 10 Perform Design

Step10

Stap 11 Vansign parameters

Step11

Stap 12 Design parameters. Run design

Step12

Stap 13 Design Result

Step13

Verificatie van resultaten

Step14
Step18
Step16
Step17
Step18

Learn more about this SkyCiv Wood Design software by visiting the specific design code page for NDS®-normen Houtdesign

Was dit artikel nuttig voor jou?
Ja Nee

Hoe kunnen we helpen?

Ga naar boven